1370 clutch

[Bigiron]

When I push the "inching pedal" in the gears won't stop and I can't shift 1-4 without grinding. It's worse when it warms up. Something simple or not so much? Thanks.

 

[1370rod]

Does it grunt when the pedal is depressed completely? Rod.

 

[Bigiron]

Yes

 

[1370rod]

Then I would do a pressure check on C1,2 and 3 with pedal depressed to make sure no pressure is present. If there is not and there should not be a mechanical drag such as warped or broken disc's would be a possibility. That of course would mean a split tractor job. If there would be pressure a pilot spool or perhaps a faulty gasket in the control valve could be the source of your problem.

 

[Bigiron]

Ok, thanks. I have the factory repair manuals so I should be able to figure it out. Does the spool normally need cleaned? And are the gaskets you speak of available to be bought separately? Thanks again.

 

[1370rod]

It is not normal that the spools need cleaning, grit and grime by-passing the hyd filters will cause them to stick in their bore. The gaskets I mentioned are the two that seal the control valve on the trans cover, there is a top and bottom. They normally do not cause a problem, but it can happen. Rod.

 

[Henrik Jansson]

Is the rear gear working?
Is the transmission oil pressure normal on the meter on the dashboard when you press the pedal down?

I had this problem when the C4 clutch was broken.

 

[Henrik Jansson]

I ment reverse gear!