Recently bought a JD 148 loader for my JD 2955 2wd tractor. The loader came with the row crop mounts and from what I have seen I need the utility frame for this tractor. Are there any of these frames still around? If not does anyone have some pics or measurements so that I can build or modify the one I have?
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
You could add square tubing from RC mounting frames to rear axles on the 2955. Shown in photo below are the utility tractor mounting frames that attach front to rear axles
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
You're welcome
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy