I bought a 14t baler that had been setting in a barn for 25 years plus. Oiled, greased freed everything up and can spin over by hand and trip the knotter and they cycled and the needles ran in and out.Started to time the baler and noticed that the needle lock didn't lock.I pulled back on the needle maybe 1/2 inch and felt the needle latch lock in. tripped the knotter again and it ran knotter cycle and the needles in and out and needles didn't latch,pulled back on needle and felt it lock. should I adjust the needle travel or control hook?I have a manual but its not to clear to me how to adjust the plunger head safety stop.
Any info or advice would be helpful
Thanks joe
Any info or advice would be helpful
Thanks joe