Finally quit raining long enough here in Wisconsin to start baling round bales. Long story short, had the 1550 on the baler, got to the field fine, went to shift in the field to start baling and the pedal feels extremely stiff and grinds the gears badly. Tried adjust the rod, but no luck, looks like a new clutch is in the works. Limped her back home, took the controller off and put it on the 5211 Zetor and back at it. Had the Hydrapower rebuilt about 5 years ago and wanted a new clutch put in but the dealer insisted there was nothing wrong and only the pressure plate needed adjustment. Guess I should have stood my ground.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy