1750 with loader

[tinmanlocal2]

I have a 1750 with loader plumbed into the remote hydraulics. The bucket cylinders bleed down a bit. I've rebuilt the cylinders. My fear is the remote valve is leaking by. Is this difficult to repair? Possibly just some o-rings or something more?



Thanks,
Darin

 

[J. W. Schwiebert]

Piece of cake. Everything is in the top cover, the part the seat bolts too. J.

 

[tinmanlocal2]

Once I open it up what should I be looking for? Is it pretty obvious what will need to be replaced?

 

[J. W. Schwiebert]

Before you start to open it up switch sides on the hoses and see if the problem stays with that valve. There are check valves inside the cover. do you have a shop manual?

 

[tinmanlocal2]

I had planned on switching the hoses around to see if it was truly in the valve. I have an I&T manual. I studied it a bit last night. Seems like there are a couple O-rings on the spool. Anything else I should look at while in there? It's gotten so cold here in the last couple days, I'm not too sure I'll be doing much on it till the weather breaks.

 

[tinmanlocal2]

I switched the hoses today and the problem stays with that particular valve. Is it a check valve problem or bad o-rings?

 

[J. W. Schwiebert]

One or the other or maybe both. You may need to lap the check ball seat as well. Do you have a phone number or post your e-mail. J.

 

[tinmanlocal2]

email is [email protected] Phone number is 660-473-0647

 

[JoeG]

Hey Tinman, I like your handle. I'm SMWIA local 55, I am in the service side of the trade.