1952ar shift fork replacement

Hello! I need to replace the shift fork on my 1952ar John Deere. I ve removed the clutch internals but the clutch housing cylinder only come 3/4 of an inch out and no further. How does it come the rest of the way off?
 
(quoted from post at 23:46:42 03/20/20) Hello! I need to replace the shift fork on my 1952ar John Deere. I ve removed the clutch internals but the clutch housing cylinder only come 3/4 of an inch out and no further. How does it come the rest of the way off?

I said shift fork but it s the clutch fork. Same issue is that I can t get the clutch cylinder off.
 
A little wiggling up and down and it should come out. Sometimes the bolts that hold the brass fork to the yoke will get caught on the housing.
 

Hi Mark. Thanks for responding. So the clutch cylinder / drum just slides off the shaft with a little wiggling? I was afraid to put any pressure on it because it felt like it was hitt something about 3/4 of an inch from its running position.
 
This pulley is on a D, but still the same. Remove the 4 bolts and pull the clutch fork from the pulley, the pulley will than slide off.
cvphoto9252.jpg
 

I had removed the 4 bolts at the start hoping that s all I needed to remove but it only comes away a little as well. So as I was looking at the fly out diagram I see there is a snap ring holding the shaft in place so surmised I had to go through the clutch to possibly get to the internals. That s when I ran into the clutch barrel issue.
 
Thanks for your help. I got the clutch shaft out and the replacement in but have to redo it because I think I have to realign the slides one more over. I m sure I m on the right track.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top