1965 Ford 3000 hydraulics

[Abbby]

Just picked up this tractor where previous owner had taken top lift cover off for some issue. Attached is what I have. Does anyone have an exploded view of this part of the tractor? Is there an online parts available for free? Figure I will put in new orings and gaskets and see what happens.

 

[jerryleight]

Does anyone have the procedure for making adjustments for a 3000 toplid

 

[Abbby]

I have the procedure for adjusting the top lid its the oil filter pickup and tube/casting that I am unsure where it goes. Looks damaged so I will likely need a new one.

 

[Andy Wickiser]

The parts diagrams are available online
from Case New Holland, link below.
CNH Ford 3000

 

[shaun wallace]

The part with the snap ring groove is back pressure valve and filter. There should be some more plumbing that goes with it. The small tube goes in flow control valve.

 

[Abbby]

Thanks for the help so far. Looks like I need one of these plus a new filter.

 

[Abbby]

Now I just need to figure where these tube and washers go.

 

[Abbby]

Ok. I got the tubes figured out. Once I get a new tube assembly with the filter on the end I need to remove the #1 metal shield so I can get the filter back where it belongs down in #2. Anyone know the trick to this?

 

[shaun wallace]

The 2 washers go on either end of spring along E clip to hold filter on. The little tube goes in flow control valve. The big one looks to be a oring that goes in accessory cover.