2750 running hot

haysaver

Member
Baling round bales and was watching the temp guage rise. Checked the top and bottom temp of the radiator with the heat gun. Top was 180 ish bottom was 140 ish. Not bad I thought may be the guage is off? Could I have a bad ground in the guage? Have had some other issues with the wiring in the instrument pannel.
 

IMHO JD left a lot to be desired in the wiring,fuse panel & printed circuit board on Mannheim 50/55 series tractors especially with SGB. Any temperature gauge can fail or read inaccurately.
 
Have recently bought two used Manheim tractors. In both cases the temp gauge sending unit was bad. Common problem???? On a 2750, found the radiator so stopped up that it overheated pulling a 7 foot sickle bar mower. With a new radiator, new 180 deg thermostat and a new temp sending unit, it still wants to run too close to the red on the temp gauge.
 
My 4255 had intermittent "overheating" problems.
It was resolved by cleaning the contacts on the instrument panel wiring harness.
 
Check the service manual. The edge of the red maybe only 195F which is not too hot.
Even 220F with a pressurized cooling system and a 50/50 mix is nothing to panic about.Fuel efficiency and combustion efficiency goes up at those temps.
 
In Addition:

While the guys below have determined that there really isn't anything wrong with 180 degrees and even 200 degrees, to prevent FUTURE overheating, keep the area in front of the radiator blowed clean of junk. Also, make sure the panels on the sides aren't filled up with gunk.

If there is gunk in your radiator core, blow it out and then determine where the hydraulic oil leak is. If you have a leak, it's more than likely those two hoses on the hydraulic reservior on the left side of the tractor, in front of the radiator.
 
Yeh, I am not overheating the guage just thinks so. I keep the screens cleen and do not have an oil leak? Radiator and condenser are clean too. I'm getting a faulse reading some how.
 
You can always put in a mechanical backup gauge. I did for my oil pressure as my dash is idiot light only for GEN and OIL press. I have it on the frame rail near the side cover where , didn't drill any holes and I can just lean a little in my seat to look at it everynow and then. Its nice to have a mechanical backup gauge to "verify" electrical one.
 
(quoted from post at 11:17:39 06/17/09) Baling round bales and was watching the temp guage rise. Checked the top and bottom temp of the radiator with the heat gun. Top was 180 ish bottom was 140 ish. Not bad I thought may be the guage is off? Could I have a bad ground in the guage? Have had some other issues with the wiring in the instrument pannel.

I've had similar problems with the electrics and the temp gauge showing false readings. It turns out that the circuit boards in the dash develop high resistance connections through bad plug-in connectors. Mine has a plug/push in fuse card and that is where most of the problems stem from.

Having said that, ensure that the radiator and screens are not clogged with hay chaff from your baling operations. I would have thought that the bottom radiator temp reading would have been lower than 140. Make sure that the fan belt is not slipping also.

Also ensure that it does have a good thermostat in place. If it doesn't have one installed (someone has thrown it away), that can contribute to overheating problems too.
Aussie
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top