2N engine miss

JoeFree

New User
My 2n always ran well, recently I needed to replace my 6V battery, as my original generator was not working properly, the batteries would drain and I was always charging the battery. I decided to try a 9V battery, and fix the generator. The tractor started easier and I didn"t notice anything different in the operation of the tractor until it developed an engine miss and loss of power under load. Does anyone know if the 9V battery could have caused this engine miss? ponts, condensor, resistors etc. Please advise.
 
Two questions: Where did you find a 9 volt battery and how do you charge it?

Battery voltage should not induce an engine miss.

Can you isolate it to one cylinder - Or is it a random miss?

Erratic firing is a classic sign of point problems. Pull the dist, and clean/reset the points. The rubbing block wears down and closes the point gap.The other thing that can cause this and is tied to engine speed is worn distributor shaft bushings.
 
The extra voltage caused more current to flow and burned the points.

Interesting observation - Never realized the points were voltage specific. Guess I'd better go take that 12 volt battery out of the 63 if that's the case.

I could see the additional current flow causing the coil to run hotter but I believe points will do okay.
 
I don't believe points are voltage specific. If they are pitted it is more likely a failing condenser or just old age.
My concern would be excessive current to the coil with the 9 volt system unless you have added some more resistance.
I would systematically diagnose this by checking spark and fuel systems. Bruce (VA) posts his method almost daily!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top