3010D 24V starter prblems

Deeredawg

New User
Can someone please tell me what voltage the yellow wire is supposed to be from the switch to the solenoid. 12V or 24V?
 
(quoted from post at 05:23:57 06/14/21) Can someone please tell me what voltage the yellow wire is supposed to be from the switch to the solenoid. 12V or 24V?

If the batteries are connected "as it left the factory" and there's no wiring "mods" the terminal where the yellow "S" wire connects at the solenoid will be at +12 Volts (nominal) with respect to chassis ground under normal conditions and at -12 Volts (nominal) with respect to chassis ground during cranking.

While cranking, with the red (+) voltmeter probe on the small "R" terminal on the solenoid and the black (-) voltmeter probe on the "S" terminal on the solenoid the meter should read 24 Volts (nominal).

HTH!

This post was edited by wore out on 06/14/2021 at 09:04 am.
 
Black volt meter probe should be (-) and red probe should be (+)

Brain cramp or clumsy fingers like I sometimes get?
 
(quoted from post at 08:45:17 06/14/21) Black volt meter probe should be (-) and red probe should be (+)

Brain cramp or clumsy fingers like I sometimes get?

THANKS for the "heads up", rvirgil, I corrected my errors!


And, DANG, I proofread that a dozen times before AND after I posted it!
 
Success!!!!! First, off, thank you so much for helping out. Your guidance brought me right to the problem (although it turned out pretty easy). At normal, the S
terminal to tractor ground was 12V. While cranking, S & R were 0 V. I checked continuity of all wires to starter/solenoid and yellow was open. Dang it. I went
over and found a loose connection on the Park switch (which I swear I checked before) but found both terminals loose. Pushed them down and away we go! I can't
thank you enough and am planning on framing your advice so I don't forget it!
 
(quoted from post at 18:03:01 06/14/21) Success!!!!! First, off, thank you so much for helping out. Your guidance brought me right to the problem (although it turned out pretty easy). At normal, the S
terminal to tractor ground was 12V. While cranking, S & R were 0 V. I checked continuity of all wires to starter/solenoid and yellow was open. Dang it. I went
over and found a loose connection on the Park switch (which I swear I checked before) but found both terminals loose. Pushed them down and away we go! I can't
thank you enough and am planning on framing your advice so I don't forget it!

THANKS for posting back with your success story!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top