3020 loader

[Charllie in MO]

I have a 3020 '69 w/a Westendorf loader that I bought here a while back and the loader controls are ran off the rear scv's. I need to change it over to a joystick and free up both of the outlets.
Can anyone help? And thank you all again for the help you have given me in the past, wish I could help more.
Charlie

 

[dogone]

call me 8165862841

 

[Charllie in MO]

Mike:
I thank you so much for your help, it's guys like you that make this forum great.
Thank you again,
Charlie

 

[JMS/.MN]

I"ve had a 3020 with 148 loader, running off the two scv"s for 30+ years. When I needed more hyd, I added a double hyd valve. Tapped into the hyd going to the 3ph. You can do the same to run your loader, and keep the scv"s for other use. In front of the brake pedals, right side, you will see a 90 degree hyd fitting. Replace that with a Tee, and use that to feed oil to your joystick. You"ll need to run a return line to a ported filter, so oil returns to the sump. My system is opposite,....I use the scv"s to run the loader, and use the extra hyd valves to run two other functions, but the end result is the same.

 

[David G]

JMS has the answer, done that works great. You just need to ensure the valve is open center.

 

[Craig C]

Closed Center