330 coil update

tarheel65

New User
Thanks to all who offered advice and ideas. Upon closer inspection I found a plug wire that had damage to the terminal end and the distributor port was corroded. I replaced points, condenser, and plug wires. With the old coil the tractor ran but died again after about 30 minutes of mowing (original problem). Put a new coil on and this time the tractor starts with the new coil and does not die. Still don't know why it would always start with the old coil but not with the new coil. With the 6 volt system, everything has to be just right. I think I may quit being so stubborn and just convert it to 12 volts.
 
There are many old tractors that are still 6 volt that start and run just fine, we have a 48 C that is still 6 volt, runs well. It's not that hard to keep them original, as long as you can find parts, and there are lots available with so many converting to 12 volt.
 
why convert. you say it dont die now? you can only die once! lol. 12 volts is a bandaid .
 
Reliable 6V regulators are becoming a real pain to locate. 12V Delco alternators are generally a dime a dozen at basically any salvage yard. They are generally reliable & not difficult to install. If you want to keep your 6V system, you are better off trying to rejuvenate an old regulator. Unfortunately, points can only be filed & adjusted once or twice & then they become scrap metal.
 
General Motors training center60yrs ago said never file or mess with the regulator and gor aq time you could not even remove the cap. The generator does the charging and the reg controls it so go back and get the gen fixed so it can do its job
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top