36 John Deere Loader question

[Lyle A Jorgenson]

I have 36 A John Deere Loader came off of a 2010 John Deere Tractor what other John Deere tractor will the Loader fit? Please call Lyle at 801-721-5968

 

[Tx Jim]

JD tractors 40T,40W,420T,S,U or W,430T,S,U or W 435,320S,U,330S or U,1010R or RU & 2010R or RU are the only tractors I found listed in pc# 870 for a 36A loader

 

[JD Seller]

The JD 2010 is a frame that is different than any other JD. The mounting brackets will not bolt direct to any other JD tractor. That 36A loader was made just for a JD 2010, at least my JD loader mounting book only shows it on a JD 2010.

You would have to modify it to fit any other models.

If you are selling it then you have a very small target group to sell to. I wish you luck. A JD 2010 is the worst JD tractor built to date. They had a bad engine and terrible hydraulics. So other than a bad engine and not having much lift they where fine. LMAO

 

[farmallron]

How can you tell the difference from a 36 and a 36a loaded and I think I got a 36 but it doesn't have the back mounting brackets can and help me out

 

[Tx Jim]

Welcome to this forum.
Part # research reveals 36 & 36A share same frame part #s AC12674 & same part #s for rear frame extensions part # AC12681 so there must not be much differences between each model. https://partscatalog.deere.com/jdrc/sidebyside/equipment/8374/referrer/navigation/pgId/1259138

 

[farmallron]

Thank you I need the mounting brackets for the rear axle or and way to mount it to my 1520 any information on this

 

[buickanddeere]

High or low pressure hydraulic cylinders ?

 

[DeltaRed]

Probably be a bolt on for other small frame JDs. However,a very small amount of mods may be needed. Loaders like that are somewhat universal.Mening they can be put on a variety of tractors. That said,I have a #36 on an M Farmall. Little mod was required( Drill a couple of holes,welded up a simple bracket.....)It's a good fit for that tractor.

 

[Tx Jim]

High or low pressure hydraulic cylinders ?

If model 36 has ind hyd control valve be sure it is setup for 1520 closed-center hyd system

 

[farmallron]

If model 36 has ind hyd control valve be sure it is setup for 1520 closed-center hyd system

It does have a hydraulic control how do I need if it closed or open

 

[farmallron]

High or low pressure hydraulic cylinders ?

Don't no how can you tell its 2 way

 

[Tx Jim]

With hyd valve pressure port attached to tractor hyd system & valve control levers in neutral, engine operating no oil should exit return orifice on hyd control on a valve designed for closed-center hyd system