Charlie C.
Member
Hi Folks, I still have a problem with understanding how the hydraulics work on my 73 4000.
I built a back blade for the tractor that uses the external hydraulics to angle the blade. The long lever in the picture is the lever that will direct the oil to the cylinder turning the blade either right or left.
When I pull the long lever towards the front of the tractor it will strike the short lever. When that occures the three point will drop to the ground. Is there something that is not adjusted right? I don't think the short lever should be in the position but that is where the pictures show it. This system is not addressed in the operators manual that I have.
Here are a couple of pictures of the blade and the hydraulic valve handles.
Thanks for any help you guys can give.
I built a back blade for the tractor that uses the external hydraulics to angle the blade. The long lever in the picture is the lever that will direct the oil to the cylinder turning the blade either right or left.
When I pull the long lever towards the front of the tractor it will strike the short lever. When that occures the three point will drop to the ground. Is there something that is not adjusted right? I don't think the short lever should be in the position but that is where the pictures show it. This system is not addressed in the operators manual that I have.
Here are a couple of pictures of the blade and the hydraulic valve handles.
Thanks for any help you guys can give.