4020 Brake Locking Problem

Denny Moe

New User
I used my '69 John Deere with syncro trans couple of hours this afternoon and everything worked fine. I then shut it off for a few minutes. When I started it back up and tried to move it it appears the brakes are locked, especially the left one, but maybe the right one slightly too. I tried breaking it loose by shifting back and forth from reverse to foreward and finally got it to go a little only the bind up again. I shut the engine off and hooked up to it with my Pickup and no problem pulling it - everything was free. So I started up the engine again and same thing the brake/brakes are locked up. I checked the hydraulic oil level and it is was a little low. I topped it off but brakes are still locking. Has anyone had this problem before and if so what is going on. Any help will be greatly appreciated.
 
If the tractor can be pulled with ease with the motor off, then I"m guessing you have an issue with the brake valve.

To test this theory, try to tow it with the motor off and see how it pulls. Then start the engine and try to tow again. If it pulls hard with the engine running and easier with it off, then I think your brake valve is suspect.

If it pulls hard regardless of motor running or not, then I"d probably consider something locking up in the tranny like a bearing in the differential, synchro shaft or elsewhere.
 
unhook the brake valve oil feed line and cap it. Start it see what happens. Its got to be the valve. Make sure that your pedals have free play and are all the way back when not pressed.. What i mean is that i have seen the pedals back and the brake pistons on the valve still compressed.
 
Thanks much guys for the response. I will try the the things you guys suggested tomorrow, weather permitting. Sounds like you both are pretty certain it is the brake valve. Out of curiosity, can the brake valve be repaired or is that something that has to be replaced. I've done a lot of mechanic work on cars and tractors, but not very familiar with the brake valve on the 4020 JD.
 
Recall this happening to my 4020 about 6 yrs ago,, it was the piston actuator right under the pedals ,,, Not to easy of a fi, Cantrecall why ,Just Seemed a little problematic taking it apart and putting it back together ,,Good luck Jim
 
you just rebuild them. Deere offers a overhaul kit for the valve. Becarefull when overhauling the valve, there are lots of parts inside. make sure they ll get back in there place. next to the brake line fittings is a cap nut. behind that nut is a screen be sure to check that. I have had them break apart plugging the valve.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top