4020 powershift dash quadrant replacement

[jd_adict]

Hi just wondering, I have a 4020 that has powershift trans and the dash quadrant area is wore quit bad between forward and reverse. I seen a few months ago a company in the green magazine or 2 cyl. club that replaced this piece. I could spend a couple hours welding and grinding on it but thought it would be much nicer to replace the whole thing, it looks like a few spot welds and it could be removed. I call this area the cactus. Cant seem to find the ad now and would like any info that I can contact these people, any help would be much appreciated. thanks

 

[D-]

Was hoping someone would help you. It would be nice to know where to get that piece.

 

[jd_adict]

Yeh, kinda disappointed at the crowd. oh well, I was just hoping to not have to thumb through the last half year of jd magazines to find the ad.
gona give it a go tonite, if I find it I will make a post later. thanks for the support.

 

[2510Paul]

Same here, I'm waiting for the answer. Paul

 

[tim s]

I pulled the dash on one like this a few years ago and wire welded a piece of 14 gauge metal in the worn place and shaped it into place,, other than a junk yard search,,,I don"t know of any other way to repair it...

 

[D-]

I have built them up with a stick welder. You don't know what a junkyard will send you. Might be worse than the one you have.
I recently got a good one but was '64 so I had to fill in key switch hole. Original one was tornado damaged.