430

[TRACTORNUTJD]

how or can i plumb in a remote on a 430 standard with only single"touch o matic"? what is dual touch o matic and is this different than a factory rear remote valve kit? thanks.

 

[buickanddeere]

Dual touch o matic has two levers to operate the rockshaft and an extra arm on the left rockshaft. It's to lift and lower a front mounted cultivator/scuffler independent of the rear cultivator/scuffler.
While the supply lines and scv valve are the same or similar from the 40,420,430,435,440,320,330 and early 1010's . The lines from the scv back to the couplers vary with the various chassis.
A factory scv while not cheap , it does look and work good. Depending in the mechanic. aftermarket valves and couplers vary from crude rigged up abominations that will bust the pump. To neat, tidy and properly functioning systems.

 

[TRACTORNUTJD]

thank you, do you know where i might find info on installing my own? I just need it for a log splitter and maybe a trail behind sickle bar

 

[Hayfarmer]

My 430 loader is plumbed as follows: pressure line from pump unhooked at bottom of dash to touchomatic housing. In to valve comes from pressure line, out return from valve goes to touchomatic housing where pressure line from pump hooked before. BE CAREFUL though as the pressure relief on valve will now determine pressure front pump puts out or tries to, when valve activated. I found out the hard way, you can crack a pump.

 

[Ray]

430 hydraulics are poor at best.I'd buy something else if you need hydraulics.