444 tin

[Gary Mitchell]

I need front side tin, both sides, and bottom piece under the dash, for my 444, (Engish maybe). Will 404, or 424 interchange? TIA gm

 

[wwoodrow]

I need front side tin, both sides, and bottom piece under the dash, for my 444, (Engish maybe). Will 404, or 424 interchange? TIA gm

IDK-BUT looks just like my 424 hood and tin

 

[wwoodrow]

I did an internet search and it indicates that the white panels on the hood are smaller than a 424 panels. If you trust Google AI...

 

[Peat]

What we did for the horizontal pieces under the hood is use the tin from an 856, or 756 or similar IH and cut to length to match up the widths on each end. Drill mounting holes and looks like factory. Found that tin was more plentiful in tractor graveyards than 444 or 424.

 

[Peat]

What we did for the horizontal pieces under the hood is use the tin from an 856, or 756 or similar IH and cut to length to match up the widths on each end. Drill mounting holes and looks like factory. Found that tin was more plentiful in tractor graveyards than 444 or 424.

 

[wwoodrow]

Looks very good.

 

[caterpillar guy]

Based on the pictures on tractor house. The front vertical piece is red to the splice going along under the top portion of the hood. That part is white. There must have been an age break in them also because it must have been later or earlier models that had the same looking hood and tin work to the 74 series tractors.