4600 injection pump

Crack the bleeder on the fuel filter until fuel flows without air. Open the bleeder on the side of the pump and let it run until the air bubbles are gone. Crack the lines at the injectors and crank until the air bubbles are gone. Tighten the injector lines and crank it over and it should fire right off.
 
Is the fuel stop open? How long has it been since it was run last? I had the same problem with my 4600 when I bought it. It sat for years and the pump was full of rust and required an overhaul. DO you have good flow into the pump?
 
it"s been setting for the winter. it would"t start this spring, so i changed the fuel, filter and lines. the filter and tank had some sludge it it. there is good flow at the pump bleeder and it even spurts fuel as i crank the engine over, but no fuel seems to make it to the injector lines.
thanks again for your help and interst!
mike
 
it"s been setting for the winter. it would"t start this spring, so i changed the fuel, filter and lines. the filter and tank had some sludge it it. there is good flow at the pump bleeder and it even spurts fuel as i crank the engine over, but no fuel seems to make it to the injector lines.
thanks again for your help and interst!
mike
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top