4630 quad range question

[chuckthisout]

Slowly getting this tractor back together but have a question. I've got the 2spd and pto gear installed and now the pto and transmission clutch operating assembly goes in. My question is that is there any kind of washer that goes in between the 2spd and the assembly where the pto drive gear goes into the 2spd? Don't remember anything there when I pulled it apart and don't see anything on parts breakdown. Hopefully pics help. Thanks again for the help.

 

[Bob]

As I recall, shaft/gear #40 is prevented from moving fore and aft by bearing #43 and external and internal snap rings #41 and #44 and no washer is used at the location you question.

 

[Cliff Nelson]

No washer needed there. 2 speed thrust is controlled inside the housing and the pto gear is retained on a ball bearing with snap ring.

 

[chuckthisout]

Ok, that's what I was thinking nothing went there but I know me and I just wanted to be sure. Thank y'all both for the replies. It's greatly appreciated!