Roberts47

New User
so when tractor in running i can only get mabie half throttle or wide open nothing between. any suggestions.

idle seems OK.
starts good.
 
It is probably the governor, but it could be the throttle plate or linkage.

There are three ways to check to check the operation of the governor. Get the throttle lever at it's lowest point (engine ideling) Then, start tapping the throttle lever slowly open. How far does the throttle move before the engine speeds up? Lack of low speed throttle response (like about 1/3 of the throttle) is the classic symptom of a bad or out of adjustment governor. Next test, put it in gear at about 1/4 throttle, put your foot on both brakes & let the clutch out. The engine should throttle up as the governor arm opens the throttle plate in the carb to compensate for the load on the engine. Next test, w/ the tractor running, pull on the rod going to the carb; does the governor pull back? If that does not work, get out the I&T FO4 manual & check out the 'adjusting governor' paragraph. Finally, before I paid $200 or more for a governor, I'd pull it off & open it up. It could just need new balls & races.

If it's not the governor, post back for info on replacing the throttle plate.
50 Tips
 
govern was rebuilt new balls races and bearings and adjusted

i found two ports in the carb that were plugged the bole vent and idle bypass. opened them up and going to put everything back together tomorrow wish me luck.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top