550 Ford backhoe

rlp in Co.

Well-known Member
I have the injection pump off and I cleaned the filter. It was about half plugged up. I hope this fixes the lack of power. How can I turn the pump up for more power? Do the springs that control the delivery pump pressure have anything to do with changing the power? I ported and polished the head and did a little work on the intake and exhaust manifolds already. I was pulling a stump out for a guy and it wouldn't even spin a tire. Of course the chain was pulling down on the tractor but still it should be able to spin a tire! I have a turbo to put on it, but that wouldn't do a lick of good if I can't add more fuel! I did try to turn it up once before and it helped a little but I can't remember exactly how I did it. Is it possible that this pump will not deliver enough fuel for a turbo?
 
If the turbo is added, injection pump should be gone through and fuel setting increase verified on the test stand for best results. Some pumps have smaller plungers, so the extra fuel may not be available for best use of a turbo. Injection pump make/model info is needed to see on the spec sheet what plunger size is..
 
Look at your exhaust while in a situation where it cant pull the load at full throttle. If you have a clutch or a torque converter and blasting black smoke, the air cleaner is plugged or the motor is toast. Adding more black smoke by messing with the pump is not going to gain a single horse power. If the exhaust is reasonably clean under this same load, then the converter is defective and needs to be rebuilt, or the clutch is slipping. The 201 was always plenty of power for whatever it was installed in, you should check other systems before condemning the motor.
 
You shouldn't be able to spin the tires on a TLB. And the 550 diesel engine is only 59 HP. You take something that heavy, 11,400 pounds, and 59 HP? Spinning the rear tires might be a neat trick.

Putting extra stress on the rear axles by drastically increasing HP may cause you to break an axle.

And face it. Most engine upgrades will deliver no more than a 10% increase in HP and most often only 2-3%. Even a turbo will only add 15-20% and still be reliable as a daily use engine. 15% on that engine will be a whopping 8.85 HP. 25% would be 14.75. On an 11,400 pound machine you really ain't going to notice much.

Rick
 
By the way , where did you find a turbo manifold for a 201? Or is it hand-built? A problem you may have with a turbo is you may not be able to turn the fuel up at all.... may even have to turn it down , if you really are in Colorado. If the air is too thin the turbo will over speed and fail.
 
Digging out stumps with a backhoe is not easy! Some of those big roots are hard to break! But if someone is willing to pay me to dig , that's what I do.
 
Thanks for the reply. This is the number of my pump. Do you think it will deliver enough fuel for a turbo and intercooler? It was rebuilt when I rebuilt the engine and only has 600 hours on it. I bored the engine out 30 thousands. There was a washer missing from the filter when I cleaned it. Number 9 on the diagram, but I guess it's not essential.I hope I didn't loose it!
DPA L3238F060. DSA 559
SER. R28102LA
MOD 085E850/7/2360
 
I think you are a little low on your hp
figures. Usually a turbo will add about 45
to 50% more hp. A intercooler will add
about 10% more hp. So I should get close to
100 hp.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top