567 bale shape error

[packratt]

Have a 567 with bale track. I just started getting an error E1 15 right shape sensor out of range.

I went to channel 7 like the manual says but when I adjust the sensor it stays at 233. I have 5v on pins a and c from monitor. Get 0ohms homing a to c on sensor.

Think my diagnosis of bad sensor is correct.

 

[used red MN]

Have a 567 with bale track. I just started getting an error E1 15 right shape sensor out of range.

I went to channel 7 like the manual says but when I adjust the sensor it stays at 233. I have 5v on pins a and c from monitor. Get 0ohms homing a to c on sensor.

Think my diagnosis of bad sensor is correct.

i have no idea if this will work, Is the left shape sensor identical, if so can it be swapped to see if the error goes away?