584 help

[Daniel Burks]

Ok, I have flat top fenders

 

[JimB2]

The difference on the flat top fenders is you have work light item #44 in right front fender and work light item #45 in left front fender fed from the top left pin with Blue/White wire, this wire also feeds the rear work light.
Do you have the 7 Pin trailer plug at the rear of the seat by hydraulic filler plug? Do you have the orange Flasher lights on top of your fenders like my brother's 495? His 684 only has the small marker lights on top of the fender, whit lens forward and red lense rearward.

 

[Daniel Burks]

My orange flashers are in the front of the fenders beside the lights. I’m not sure about the 7 pin. I’ll check in a few and get pictures of the fenders

 

[Daniel Burks]

 

[Daniel Burks]

 

[Daniel Burks]

There are wires on the back that I assume would have gone to a plug at some point, but the plug has been removed/broken

 

[Daniel Burks]

I may have figured it out. The fuse holder is melted behind the fuse, it shows good on the fuse side but nothing leaving. Thanks for the help! I guess I’ll add a spade fuse holder or maybe add a relay since it calls for a 35a fuse.

 

[JimB2]

Good looking 584, it does have some IH Louisville, KY, USA options, so my wiring diagram may not be 100% compatible.
Fuses 3 and 5 are used for the lights, Fuse 4 appears to be a spare.
Good luck
Jim

 

[used red MN]

I may have figured it out. The fuse holder is melted behind the fuse, it shows good on the fuse side but nothing leaving. Thanks for the help! I guess I’ll add a spade fuse holder or maybe add a relay since it calls for a 35a fuse.

The relay sounds like a good idea, just make sure it is rated for the amperage and for constant operation.

 

[Daniel Burks]

Good looking 584, it does have some IH Louisville, KY, USA options, so my wiring diagram may not be 100% compatible.
Fuses 3 and 5 are used for the lights, Fuse 4 appears to be a spare.
Good luck
Jim




View attachment 135478

Thanks! Could you possibly email this to me? I cannot open it fully.

 

[used red MN]

Thanks! Could you possibly email this to me? I cannot open it fully.

I would recommend you contact Jim through a Direct Message to share email addresses rather than post them on an open forum. Click his username by his reply and you’ll find the option there.

 

[Daniel Burks]

I would recommend you contact Jim through a Direct Message to share email addresses rather than post them on an open forum. Click his username by his reply and you’ll find the option there.

Thanks for the advice. He messaged me.