6 volt battery

I'm stumped!!! Have a 6 volt battery on my AC/G that shows full charge (6.85 v) and load test OK. BUT it won't turn the motor over. Played musical batteries and the one from my AC/WC worked fine. Put the G bat in the WC and same thing, no workeeee. Any ideas?

Thanks
 
Put the battery in a tractor. Put a good volt meter across the bat posts. Try to start it (neutral and brakes) The voltage should be 5.75 minimum when cranking. If there is not, there is either a bad cell, or a bad internal connection. Wear glasses and be careful, it could be a dangerous battery. JimN
 
You can have voltage but little or no amperage when you put a load on it. Check the voltage while cranking the engine and see what it does.
 
From what you say, I have to question the accuracy of that "Load Test" you mentioned. After all, assuming a good starter (must be if other batterys operate it) and good cables and a ground (again must be okay if another battery starts it) NOW THATS A REAL LOAD TEST WHEN AN ACTUAL STARTER MOTOR IS USED......

I like Jims approach, because thats what a load tester does, it pulls a heavy draw out of the battery and then measures how low the voltage drops. Its my guess it will FLUNK that test lol

John T-
 
Check for voltage at the starter when you try to crank it. You may have an internally broken post that only shows voltage, but under load, nothing.
 
Check your cables! Probably biggest mistake made with 6 volt is if someone repalced a cable they didnt put heavy enough cables on it, 6 volt takes heavier cables then 12volt. Hook up a GOOD set of jumper cables along with your original cables from battery to starter and see if that helps if it dose it your cables!!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top