'68 4020 PTOproblem

[JBarbee77]

Have a 4020 power shift. The PTO dosen't fully disengage. When I have the lever in the off position, the PTO is still spinning. Is there an adjustment for that, or is something worn out?
Thanks

Jason

 

[Tx Jim]

It's possible nut(parts key#32) in 1st photo is loose. If that doesn't help you might adjust clevis(parts key #6) in 2nd photo.

 

[tim s]

Also check to see if dirt is built under the lever (29 b) it gets nasty down in there ...

 

[Tx Jim]

Thanks Tim I forgot about the possible DIRT buildup.

 

[tim s]

This guy should check all these things but,,,it"s probably a deeper problem, the power shift PTO is the most troublesome part of the system,,Darn it

 

[JBarbee77]

Thanks guys for the input. I just have one more question. Where is the first picture located in the tractor? I see the cluch petal, is it under the platfrom or on the side? I can"t tell by the pic. As always thanks for the input.

JasonJason

 

[tim s]

It's in behind the dash..lower left..

 

[Tx Jim]

As Tim stated behind the dash cover door on lower LH bottom.