70 D Loose flywheel

JMJ

New User
Ive been trying to chase down my nasty clutch noise on my 55 70D for the last week or so and i think i found it. My flywheel has come loose. I dont think its been loose too long though because its probably only ran a total of maybe 5 hours so far this year and last winter it was still tight on the splines.
Now however, i grabbed ahold of the top of the flyweel and got around 1/8" of play @ the top of the wheel. I took the bolts out, the nut off, and pulled the flywheel. I put one of the bolts in a vise and threaded the nut on it to see how far i could get the nut to go and it wont go on any farther than when it was in the flywheel. The spines on the crank and in the wheel are all shined up but dont really seem to be crowed they still seem fairly flat.
So the question is for those that have been there and done that. What are my chances that a new set of bolts will hold this beast togeather? Or would i just be delaying the inevitable in needing a TAPER LOK? :oops: :oops:
 
Chances are very good that a new set of grade 8 bolts and nuts will hold it for the rest of time. Be sure to torque them to 120 ft lbs or so and you might sweeten them up from time to time too. I'll never feel safe about a flywheel that has come loose once before.
 
Fine thread blts will have more clamping force than coarce thread and a flat washer under the nut will help too.
 
There is a enough clamping force to crack the flywheel with coarse thread grade 8 bolts. Fine thread doesn't add a significant amount of thrust.
It's true a hardened washer is required to eliminate galling and provide accurate torque.

3/4" grade 2 bolt coarse torque 173ftlb thrust 14,000lb
3/4" grade 5 bolt coarse torque 266ftlb thrust 21,000lb
3/4" grade 8 bolt coarse torque 376ftlb thrust 30,000
3/4" grade 2 bolt fine torque 192ftlb thrust 19,000lb
3/4" grade 5 bolt fine torque 297ftlb thrust 24,000lb
3/4" grade 8 bolt fine torque 420ftlb thrust 34,000lb
 
I would try a fresh set of bolts. You don't have much to lose. I like the fine threaded ones as they absorb the torque a bit more smoothly. Albert @ Renaissance Tractor suggested those and I bought a pair from him. He rebuilds the big diesels for a living and really knows his way around them.

Buy or rent a GOOD torque wrench. I have one of those larger Proto brand, 3/4" drive, that can go to 450 or so. Go up in a few stages, and now is the time to make sure everything is correct with the thrust washers behind the flywheel. Bolts might not be all of your problem. If the crank has been hammering sideways, it makes for a loud clutch, too. I made a spacer as suggested in the JD service manual to simulate the thickness of the flywheel so that I could make the adjustments before hoisting it into position. Don't you love that Florida condensation...

IMGP0352.jpg
 
You might as well save your time with new bolts and trying to tighten.Splines worn on crank.I have in the past used shim stock and cut stock put in splines then tighten.Not a permenet fix but it will work takes lots of time and patience.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top