750 series backhoe backfill blade

[Ray T.]

I am looking for information for a Ford backhoe bucket backfill blade. The Ford part number is 19-260 and it is suppose to bolt on to an 18” or 24” backhoe bucket. A picture is shown in the 750, 753, 755 series Ford Backhoe operator’s manual and it is mentioned on the Ford parts sites, but it is no longer available. The Operator’s manual indicates it is 17-3/4” high and 48” wide.

I can’t find any additional information about it online. I would be tempted to try and make one, but the only picture I have from the manual doesn’t show any detail so I am not sure what the brackets look like and how it bolts to the blade and bucket.

The 755 backhoe I have is mounted on a Ford 4500 TLB.

Does anyone own this blade or possibly have seen it or know of an aftermarket alternative?

 

[ptfarmer]

Wouldn't be hard to make one, or have one made, this one is for a Bobcat excavator.

Or you could take a old bucket, and weld a cutting edge on it like this.

 

[Apache_58]

There are various methods of attaching a snow plow blade to a loader bucket. You might be able to get some ideas from that.

 

[Apache_58]

Never mind, missed the fact that you were looking for an attachment for excavation bucket.

 

[JoeM(GA)]

if I remember correctly, it had a angled lip on the back for the teeth to fit in and then pinned
on each side to holes in the side cutters of the bucket.

 

[Sean in PA]

Below is a picture from the [u:39bb0dd0eb]Parts Page[/u:39bb0dd0eb]