7740 steering issue

Lukesdad

New User
I did a quick search through archives and didn't come up with anything on this, but I could have missed something. I have a 7740 S that loses steering intermittently when steering left. The steering wheel will continue to turn and the wheel cylinder / wheels will not. Sometimes but not all, I can turn it in the right direction then back left and the wheels will turn, but not always. Never happens when turning to the right, and doesn't happen in any particular spot. Also seems to be worse with load on the front end (hay or a bucket full of dirt) and thay may have been what started it, but it is getting worse and now does it with no load intermittently.
Should I start in the steering cylinder or the steering box? I would think pump / bypass are good if right hand turn works every time.
Thanks.
 
The intermittent nature of the problem and that it seems to be only in one direction makes me think it may be a problem with the steering motor.... BUT ALWAYS, ALWAYS check the cylinder first. What I'd do is remove the hose from the opposite end of the cylinder and try to steer to the left... If you have oil bypassing the cylinder internally and coming out the open line on the cylinder (not the open line from the steering motor)... then that would suggest to me that the center seal in the cylinder is shot and it needs resealing. That would be the best case scenario for you. If not then I'd expect the motor to be the problem and that will be expensive and not so terribly easy to change most likely...

Rod
 
Some other thoughts.... The steering cyl has the force of the full piston surface on one side and the smalller piston surface on the other side, due to the rod in the cyl making one side smaller. Therefore.... with that ideal in mind..... weak power steering pressure, bad thrust bearings, and on one tractor, super hard grease can make it do something very similar. iirc a 7740 had a different source for power steering, or at least a much different looking pump. I would jack it up and manually turn the wheels checking for freely turning spindles, and look at the clearance above the axle support on the spindle. if the spindle shows excessivly on top of the axle support when sitting on the ground, the thrust bearing has collasped and loading down the steering as well. The high cost of the steering motor means that everything else should checked first.
 
I picked up a bale of hay and checked it at standstill (instead of rolling) and it wouldn't turn. At standstill with the left hand turn in motion, the low pressure side cylinder port showed a high flow of oil. (Same port no flow with steeing wheel not in motion). I also tried the same test with the opposite hose disconnected and turning right. THere was still flow but significantly reduced. I had to do all this quickly becuase was in a hurry and the supply lines were puking oil out the whole time. Raised up all the bearings and wheel movement seemed ok. Seems (hopefully) the cylinder is the culprit. If not I'm out $38 and some time on a seal kit which will virtually disappear if I hve to go into / replace that motor.
Thanks again.
 

interesting because the same seal works between both sides and is used for left and right turns.. Again, the cyl is cheapest place to start.. good luck.
 

did you raise the front end off the ground, and grab a tire and turn it manually stop to stop, with the engine turned off???? That will tell you something as well. It will be difficult but should turn if spindles are free and not binding. It will not however tell you if the thrust bearings are good as they dont load till weight is on the spindles.


let us know what you find.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top