801 engine noise

Eddie Buck

New User
Today while I was off the Ford 801 diesel left idling, and was changing implements,the engine seemed to start missing and started knocking like the valves were chattering,pinging or high pitch knocking getting louder and louder.I ran and cut the engine off.About thirty minutes later I decided to start it at a low idle and try to find the location of the noise.Well the engine ran good and no knocking.The problem is I"m afraid to run the engine faster for fear of a rod going through the block. Anybody ever had that happen? What could it be? Oh,has full oil level.. Kinda sounded like an engine sometimes when it starts knocking a few seconds after using ether.Could it be caused by water or trash in the fuel? Thanks Eddie
 
Eddie,
I had an 82 GMC pickup with a 6 cylinder. I was leaving work one day and man did it start knocking just like you explained. Everyone looked and I shut it down. Checked the oil and all was okay. I started it back up and the noise was gone. I drove it home of 30 miles and it ran fine and ran fine ever since. I was told that it had to be a chunk of carbon break loose in the combustion chamber to cause the noise. I never did find out what caused it.

I've also seen v-belts on forklifts cause a noise that sounds like a rod knocking and I swore that's what it was at the time, until another mechanic came up and poured water on the belt and the noise went away.

If the noise on your tractor would stick around for a period of time I would be concerned but run it and see if it does it again, if it does then I would quickly try to diagnose it while it's running.

If you find it let us know what you find!

John
 
Usually,but not always,if a rod is knocking it will keep knocking and get worse.Maybe a slug of water went through and caused a cylinder to quit firing?
 
Usually,but not always,if a rod is knocking it will keep knocking and get worse.Maybe a slug of water went through and caused a cylinder to quit firing?
 
Hopefully it was just a drop of water or carbon.I keep a close eye on oil pressure.Sixty pounds idling seventyeight-eighty pulling harrow.I even made a couple rounds pulling harrow after I cranked it back up and it ran fine,but I didn"t run full throttle.Didn"t want to risk a rod going through block..This morning I cranked it up and let it idle as slow as it could without cutting off,and it ran fine with no knocking and stayed at sixty lbs OP.Anyway,thanks folks for your helpful advice. Eddie Buck
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top