8200 tractor

[islandgreen]

3pt cylinder lower pin hard to remove any suggestions. Lloyd

 

[jd_adict]

I was wondering the same thing.
I have to remove the lift cylinders on my tractor to rebuild them.
what about welding a threaded rod on it and then using a bushing and washers with a good oiled up nut.
tighten the nut up to pull the pin out.
once its out cut off the rod.?

 

[matthies]

Was thinking I just pulled the top pin and pivoted the cylinder out enough to pull the ram and replaced the seals and reinstalled the ram. Its been close to twenty years though. Also this was after I had the 3pt lowered and then raised the hitch with a jack and without the top pins.