841 Exhaust Studs

[RICK IN GA]

Anybody have a good source to get these? The NH site says 7/16 14-20 and 1.78 in length. Can't find them anywhere yet. Anybody have a recommended bolt instead? Thanks Rick

 

[Dean]

Common size.

Should be readily available at just about any good auto parts store.

Dean

 

[souNdguy]

Carquest had ones I needed. actually they had most of the ones I needed. I had to use a long one in the forward hole as they ran out of the correct ones. no biggie. more wrench turns and a deepwell socket.

 

[RICK IN GA]

Thanks Fellas, I appreciate your help! When I started looking I went to the NH dealer and the parts guy looked it up and it said "Procure Locally". He had nothing to offer as to where I could get them.

After I got your advice I checked online at NAPA and their online search is horrible. No dimensions are shown. So I went to the distribution facility which is about 1/2 mile from my job and the guy there took about 1/2 hour and had to call the manufacturer of the studs. He did find some but I noticed that they weren't grade 8 so while at NAPA I checked with Carquest and they have the Grade 8 studs in stock also pretty close to my job so I'll get them there.

The most frustrating thing with this site is the search engine. I can't seem to find old posts I remember for anything. I was kicking around getting the upgraded ignition switch from NAPA and remember someone posted the part number here and haven't been able to find it.

Thanks again for your help. I have been a loyal follower of this site and a parts purchaser when possible because so many of you guys have offered so much over the years. How old is this site? Seems like I used to get on here 15 years ago.

RIck