8n 3pt hitch

The pin on one of the lower arms of my 3pt hitch has sheared off and the nut came loose inside the axle housing. How hard is this to fix and what all has to come off to get to it?
 
To get to it, you need to remove the axle trumpet. If you remove the left trumpet, you can do them both at the same time. It's held on by a castelated nut w/ a cotter key on the inside. Drain the fluid (see tips 3 & 4, below) Remove the left trumpet & slide the differential gear out. (an engine hoist is a good idea) Make sure the holes are not wallowed out or you will be in there again. I hear JB Weld works, but I've never had the problem so I can't say for sure. Torque the nut on the new pin to 150 lbs before you put the cotter key in. Wipe the new trumpet gaskets w/ warm water & let them set a few minutes before you put them on. Torque the 11 trumpet studs to 40 lbs.
50 Tips
 
Oh does this sound familiar. Have not been able to get to mine yet Bruce, because I tore up my knee and just has surgery. But it brings up a question, can you pull the trumpet without having to remove the axle shaft out of it? And if so, I would imagine it would have some weight to it, so it would be a good idea to have the hoist supporting it first?
 
You're not going to get the trumpet off w/o the axle coming w/ it, but if you're worried about the weight (and I would) pull the axle out. But, as I mentioned above, get a engine hoist, aka cherry picker & pull the trumpet & all at the same time.

I'm not 18 anymore either.....I use the cherry picker to pull top covers.
50 Tips
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top