8N electrical issue

heybrau

New User
My early 8N with a front mount distributor had been converted to 12V by previous owner. The voltage regulator is in place but not hooked up.
Is this normal with the conversion? Also the amp gage shows no charge or draw. The tractor starts fine but I"m not sure it"s charging. One more thing; what does the resistor do?
 
(quoted from post at 19:44:30 08/20/13) My early 8N with a front mount distributor had been converted to 12V by previous owner. The voltage regulator is in place but not hooked up.
Is this normal with the conversion? Also the amp gage shows no charge or draw. The tractor starts fine but I"m not sure it"s charging. One more thing; what does the resistor do?

Since most 12v conversions use an internally regulated alternator, your voltage regulator is essentially a paperweight. Depends if you have a modern alt or 12v generator.

The amp gauge not working means it is not in the charge circuit. It can be wired in to work if you want. Google "wiring diagrams by JMOR" for all the wiring info you'll need.

To tell if it's charging or not, get it running at about half throttle. Using a meter on your battery post, you should read around 14v if it's charging.

What resistor are you talking about? OEM ballast behind the dash or one added in line?

Really it doesn't matter. Either one is modifying the amount of amps sent to the coil based on voltage.
 
Take a voltage reading of the battery before you start the tractor and again after you start the tractor. If the alternator is working the after reading will be higher. If the amp meter needle does not move it may be broken or not hooked up. The old 6 volt regulator may have been left in place because it was not in the way and the PO did not feel like doing extra work to remove it. The front mount coil needs a resistor. If it is a 12 volt coil it needs the original ballast resistor that is mounted on back of the dash. If the original 6 volt coil was used it needs two resistors, the original ballast resistor and another resistor of around one ohm. The resistors are to keep the current down going through the coil so it does not burn up.
 
alt or genny. if alt. reg is probably just there as a wireing point.

as a general rule of thumb.. a new 2.5 ohm front coil and the oem ballast resistor play ok together on 12v. if it is an oe 6v coil, then you need ballast resistor plus a converting resistor. may types available depending on exactly what ya got for a coil.

as tot he ammeter.. is it hooked up as net charge discharge?

one sid eof ammeter to battery hot ( solenoid connection is easy.. ) other side of ammeter has alt charge lead and ALL electrical loads.

oem ammeter was a looper inductive job.. new style are post style.. mount and work posts the same.. using insulation grommets to not short out. post ammeters make good load center wire points.. .. ez to wire up
 
Thanks everyone. The resistor is the original and it looked pretty old, that is why I asked.

The amp meter shows 10 amps when I hook a 10 amp charger to the circuit with the engine off. I think the meter is working fine. The battery shows no difference in voltage with the tractor running or not, 12.8 volts.

I think the alternator is bad.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top