8n Ford sheet metal

[[email protected]]

I have a 1950 8N Ford that I need some pieces to weld in the hood after I cut out the bad spots out. I posted this back a few days ago and had some answers. One said he had an old hood that he might be able to cut out what I needed. I replied to him and told him what I needed. For some reason I cannot find the post or the replies. If the one that replied please contact me again. Thank you.

leroy1142

 

[BigDanT]

leroy...wasn't me that replied before but i have a couple of hoods I could let you cut up.(No charge) Where are you located? I'm in central Indiana. If anywhere
close send me an email or call 317402923four. Dan

 

[[email protected]]

(quoted from post at 02:41:47 06/23/16) leroy...wasn't me that replied before but i have a couple of hoods I could let you cut up.(No charge) Where are you located? I'm in central Indiana. If anywhere
close send me an email or call 317402923four. Dan

I need the lower edge with both beads on the right side looking out over the hood. I need from the center line around the curve to about 18" to the back of the hood. look at the hoods and If the hoods you have are good there I would be interested. I live in Bartlesville, OK.

I thank you for your response

leroy1142