9' IHC Wheel disk

[chuck machinist]

What were the model numbers for the IHC 9' wheel disks in the late fifties , early sixties? Chuck Machinist
I would like to add one to my herd

 

[NY 986]

What were the model numbers for the IHC 9' wheel disks in the late fifties , early sixties? Chuck Machinist
I would like to add one to my herd

Most likely the model 37. Angle iron frame.

 

[chuck machinist]

A hens tooth? Heading out to Desmoine Ia area in June. I would like to take one back to South East Va, Chuck Machinist

 

[NY 986]

A hens tooth? Heading out to Desmoine Ia area in June. I would like to take one back to South East Va, Chuck Machinist

A fairly common disk. There should be a few between SE VA and Iowa. You may want to think about a WTB ad in Red Power magazine.

 

[caterpillar guy]

You will need to remove the tongue or get oversize permits for it if you do find one. 9 wide is over the 102 or 8'6" legal width. With it loaded cross ways and the tongue off it would probably be a legal load then. Most states west of Ohio probably would not say anything OH and east probably would.

 

[chuck machinist]

Thank you all for your insight!. Hopefully several bolts. out of the tounge.when lifted vertical , then pinning it is possible. CM.