961 Powermaster

[Brad Miller]

I have a 1959 961 Powemaster and need the right side 3 point lower arm bracket. It's a cast iron 3 hole bracket and having no luck finding one. Any help would be appreciated. Attatched is a picture,

 

[Larry NCKS]

best try again. I see no picture.

 

[souNdguy]

not an awesome pic of my 950.. but the rowcrops have that funny hanger bracket.

You will be lucky if you find one salvage.

I bet you could make one out of mild steel, a torch and welder.. etc. and some playtime.

soundguy

 

[sixbales]

Have a look in the salvaged tractors section at external_link

Thay have three 961"s listed, don"t know if any of them have what you"re looking for.

 

[Vito]

Brad, Sent you a email.I believe I have the part.

Vito

 

[showcrop]

(reply to post at 14:13:02 12/16/11) [/quot

I have one. It is still on the axle that I just dug out of the shop and put under my old post and beam barn last weekend. I suppose I could take my torches out there to see if I can get it off.

 

[showcrop]

(reply to post at 14:13:02 12/16/11) [/quot

I have one. It is still on the axle that I just dug out of the shop and put under my old post and beam barn last weekend. I suppose I could take my torches out there to see if I can get it off.

 

[Ultradog MN]

I see this is your first post.
Welcome to the Ford board.
They won't let you post pictures till you have a few posts. Keeps out the spammers and hooligans.
Looks like a couple of the fellows here can help you out.
Good luck.

 

[stockman]

Cheap tractor parts in Kentucky has one on ebay for $75.