Alternator pulley advice needed

The 10SI on my loader 8N crapped out last week and I ordered a kit from this site to freshen up the wiring and all in addition to the replacement alt. Problem is that the pulleys included with the set are too small! The fan belt is proper sized and only a couple months old but there just isn't enough adjustment to tighten things up properly.

Should I look for a smaller belt or buy in a larger diameter pulley?
 
(quoted from post at 12:33:18 08/30/17) The 10SI on my loader 8N crapped out last week and I ordered a kit from this site to freshen up the wiring and all in addition to the replacement alt. Problem is that the pulleys included with the set are too small! The fan belt is proper sized and only a couple months old but there just isn't enough adjustment to tighten things up properly.

Should I look for a smaller belt or buy in a larger diameter pulley?

Both of mine on side mount 8ns worked great, I would get a shorter belt rather than a larger pulley. a larger pulley may affect the speed at which it starts charging. is yours a front mount?
 
I didn't even think about proper RPM's for charging, that makes perfect sense. The tractor is a front mount.

The alt that was on there has a larger sheet metal pulley than either what is on my other two Ns but I can't get that thing off even with application of heat or break-free.

New pulley is about $15, new belt roughly the same.
 
If you bought the kit for the front mount dist, it should have came with anew fan belt of the correct length.
 
It did and I tried that one as well; both are just slightly too large. I wonder if the pulley installed for the loader is a smaller diameter than stock...That could account for the very slight slop. I think if the alt pulley was maybe a quarter to half inch larger it would be able to carry the proper tension.
 
Just went through the same thing with mine,apparently some of these old conversion kits had a larger(3 1/2 inch)pulley.I could not get my pulley off either so I ordered a new alt. from this site,i should have it Friday.If there is any length problems I will just buy a different belt as I could not find a 5/8 wide pulley that was 3 1/2 od
 

98-NAA5825 pulley would be the correct pulley for a 5/8" belt that's it bar none the right pulley for the application... Understand this its the only one for your application that's correct... I think it measures 2 1/2" in diameter...

Some conversion kits come with what they call a universal pulley there is no such thang !!! They made it up cuzz its CHEAP Its for a 3/4" belt nuttin universal about it other than its not for a 5/8" belt... When all is new it will work when a little ware sets in its gonna cost you...

This is a pix of the universal 5/8-3/4 pulley its not correct !!!

AltPulley.jpg
 
Good evening,
I just finished installing a 12v conversion kit and used a 2 1/2" pulley that is made for a 5/8" x 44" belt and it fits fine.
Good luck.
Scooter
 
This is the pulley that came with my one wire 6 volt 10SI. Putting a larger pulley on the altenator won't excite and charge.
better to find a shorter belt.
a170607.jpg
 

Yours has the wrong pulley you got the shaft... In time it will be a issue once a little ware sets in you will be consistently undercharging the battery...
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top