I have a 1948 8n tractor that has been converted to a 12 volt system. Amp meter is not connected to anywires . Where can i find information to make proper connection for the amp meter. I plan on just buying a new gauge. Not sure if this gauge is even working. In any case i do want to make the proper connection to make gaug operarational.

Thanks Navy Davey
 
See if this will help, compliments of JMOR:

a767.jpg
 
For a buggered up non oem wire setup.. the easiest way you can get a net charge / discharge meter is to connect the bat connection to one side of the meter.. and the alt and all loads like ke lamps and ignition to the other side of the meter... charge tot he bat will make a positive deflection.. discharge fromt he bat with engine off will make a negative deflection.. otherwise alt carries the electrical loads.. etc.

soundguy
 
Soundguy has it right, but let me add the following: (1) use the small wire coming from the place where the non-grounded battery cable attaches to. (2) if the ammeter reads backwards simply switch the wires on the back of the meter.
 
Wanna hear something really weird. My Ammeter isnt hooked up, but a wire goes through a holt in it, and it reads when the tractor is running!!!
 
Leeworthy, that is the way it is supposed to be. The original gauges did not have post/nut connections. The wire ran through an induction loop.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top