The amp gauge on my 650 has a bad seal and I want to replace it before I put the loader back on.
If I decided to install a volt gauge instead of replacing the amp gauge, can I just hook the wires up the same way on the two posts or is special wiring needed?
The previous 12V conversion would require a 12V volt gauge, but is there a difference between 6V and 12V amp gauges?
Thanks.
If I decided to install a volt gauge instead of replacing the amp gauge, can I just hook the wires up the same way on the two posts or is special wiring needed?
The previous 12V conversion would require a 12V volt gauge, but is there a difference between 6V and 12V amp gauges?
Thanks.