Back by popular demand

[TheOldHokie]

I have received numerous inquiries about the under axle adapter brackets I was making for mounting the SDA6 swinging drawbar assemblies on a 9N/2N tractor. I sold out of the ones I had quite a while ago and there was so much interest I now have a new supply of what I think is an improved version.

Here are a couple pictures of the new brackets on my 9N. There are two to a set and made from 3/8" plate. They bolt up to each side of the center section using the three lower axle housing axle housing bolts. The SDA6 clevis is then mounted to the brackets using 5/8" cap screws (and nuts) in much the same manner as on the 8N and NAA. Very sturdy and easy to install. If you are one of the folks that called and wanted one of the the old version call me quick. I will be putting these up on the website and I suspect they will go pretty fast.

TOH

 

[Ultradog MN]

Nice job TOH!

 

[warbaby]

Nice!


Now, if I could just get you to make another run of SSK-FD-PROs...

 

[TheOldHokie]

(quoted from post at 14:44:23 10/20/21) Nice!


Now, if I could just get you to make another run of SSK-FD-PROs...

Com


Even more in demand but a heck of a lot more time consuming for me. Sometime this winter when the weather drives me back inside. Keep rattling my cage.....

TOH

 

[Benj R]

Hello. Would you ship to Canada? Thanks Ben.

 

[TheOldHokie]

(quoted from post at 19:56:26 10/20/21) Hello. Would you ship to Canada? Thanks Ben.

Yes but you are looking at $55 USD for shipping.

TOH

 

[JMOR]

(quoted from post at 20:07:27 10/20/21)

(quoted from post at 19:56:26 10/20/21) Hello. Would you ship to Canada? Thanks Ben.

Yes but you are looking at $55 USD for shipping.

TOH

K, I surrender.......what is SSK-FD-PROs ?

 

[Abbby]

How does the drawbar mount? Seems on an 8N there are two mounting points.

 

[TheOldHokie]

(quoted from post at 20:20:42 10/20/21)

(quoted from post at 20:07:27 10/20/21)

(quoted from post at 19:56:26 10/20/21) Hello. Would you ship to Canada? Thanks Ben.

Yes but you are looking at $55 USD for shipping.

TOH

K, I surrender.......what is SSK-FD-PROs ?

 

[TheOldHokie]

(quoted from post at 20:34:40 10/20/21) How does the drawbar mount? Seems on an 8N there are two mounting points.

Same as on the 8N. The SDA6 under axle clevis bolts to the adapter brackets and the drawbar support bracket bolts to the 9N/2N PTO housing. When I get a chance I will put the full SDA6 kit on the 9N and put some pictures up on the website.

TOH

This post was edited by TheOldHokie on 10/21/2021 at 05:58 am.

 

[PopsH]

TOH - I'd like a set of your drawbar adaptor brackets if available. How much do they cost (I'm in Georgia, USA)?

Thanks.

 

[TheOldHokie]

(quoted from post at 18:18:23 10/21/21) TOH - I'd like a set of your drawbar adaptor brackets if available. How much do they cost (I'm in Georgia, USA)?

Thanks.

Going fast but a few still left. Pricing and ordering info can be found here:

SDA6 Adapter Brackets

How To Order

TOH