tgoschwartz

New User
New to this forum so I hope I abide by rules and expectations. I am looking for a used bale sweep. I am a realy small operation and do not have anyone to stack square bales.
Do any of you know of a bale sweep ala Rocky Mountain Bale Sweep for sale?
Please advise.
Thank you
 
Not sure if we are on the same page,but we used a bale accumalter,it was something so the single bales, weren't laying all over the field, it was something you could build yourself if you had a welder, chop saw etc, It would open up with a rope trip and close itself, on the go!Farmhand Co, out of Hopkins Minn, had one, but i built mine wider and longer so it would hold ten bales easier,
 
Thank you for your input. I am on the verge of making one, but was hoping I could avoid embarassing myself with my welding.
 
If you really want to I am sure you could bolt most of it together.I am a good welder but sometimes its better to bolt things together especially a high stress area
 
I have a 8 bale accumulator, I would sell the first $1800 gets it. I think it is a farmhand. It has never been inside but it worked last summer. I live in SE Illinois. 618 599 8041
 
I went and looked at a Rocky Mountain bale sweep. It is simple.but takes a tractor and loader. Mine can be pulled.behind your baler. Or pulled with anything like a side by side. It unloads automatically when it gets full.
 
I have an accumulator that stacks 6 bales in a pyramid so the rain will shed off of them and the strings will not touch the ground. Works well but since the kids are all gone, I dont bale anymore. Located near Ipswich, SD. My email is open.
 
(quoted from post at 02:54:53 01/31/22) But then you still get to load them on a trailer by hand unless you have the fork to go with it

True, but having bales in clusters of some type, is still better than walking to each individual bale to pick them up. JMHO
 
There is a classified section on this site. You could try posting an ad there. For sale and wanted ads are not supposed to be posted on the discussion forum areas of the site. "Does anyone know where I can find?" type posts are kind of a gray area.
 
Thanks to all of you that responded. If I understand the use of the Rocky Mountain Bale Sweep version correctly, you can, with your front loader or skid steer, off load them onto the wagon by tipping the nose down and pulling back. If this were not so, then I would have to stack them by hand.
I thought about bolting them as suggested here, and then just welding the end of the threads to keep the nut from backing out.
Thanks again to all. I will keep you updated.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top