Be it ever so humble....

kcm.MN

Well-known Member
Location
NW Minnesota
Puzzle: https://jigex.com/2wH7

mvphoto68702.jpg
 
Reminds me of a place where we attended an auction once... except there was much more rust setting all around. :)
 
I think its a Chev, and the OHV 6 would have been original. They had a 206 cubic inch through 1936, then 216 after. My '36 pickup would float the valves at 38 MPH, which effectively acted as a governor. You get to watch a lot of scenery at 38 MPH.
 
I have a running 1933 engine and four speed transmission for that truck, in a doodlebug. 1 1/2 ton truck engine and transmission.
cvphoto72194.jpg
 
That is a good looking rig. Smaller than most doodle bugs , like a vintage JD gator. Where is the gas tank?
 
Yep, your are correct.
I was about to post the same thing.
And most folks don't know that Chevy produced a V8 in 1917 with overhead valves and a cone clutch.
I had a running 1925 Chevy with a 4 cylinder and open overhead valve system with pushrods showing on the side of the block.
Richard in NW SC
 
Selling the property and everything on it. Sawmill is sold but still here and can be run. Someone coming tomorrow to look at the doodlebug.
 
That truck looks identical to our 1935 Chevrolet dump truck. It had a 206 OHV 6-cylinder engine and served as a county road truck many years before my grandfather bought it. He took the steel box off, and put a flat bed on. The hydraulic dump is what kept it out of the scrappers hands. You don't see as many Chevs as Fords of that vintage, because Chevrolet used so much wood in the body. Fords were all steel.
 
Years ago I rebuilt my dads doodlebug that had a 1928 Chev. 4 with a 3 speed and a model T truck rear end. 20" on rear and 16" on front.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top