Bendix starter drives

manni52

New User
Hey, everybody:

Since I am new to the forum, and my 8n, I will have many questions that I sure could use help with. The next is with regards to the starter. The old drive crapped out and I have a new replacement that is different but I am convinced it will work onna counna many vendors are selling this particular drive. The question is 'what is the best way to insert the retaining pin through the hole in the drive when it is partially blocked by the washer on the rear of the ratchet housing'. I cannot compress it like I did with the old drive with the large spring. I tried using large pliers but stopped short of making a mess. Anyone?

Thanks in advance!

-John
 
I made a tool for mine. Take a pipe (4-6") large enough to fit over the washer. Drill a hole through the pipe, 1/4". Cut the pipe into at the hole. You can now press the pipe tool down on the starter and stick the pin through.
 
Hey everybody, Happy Fourth!

Just thought I would get back those who assisted me with my Bendix drive. I came up with my own solution after some amount of dinking around which may be helpful to others. I realized that the large retaining washer that was giving me a hard time at the back of the drive actually rotates in its groove. I used a rattail file approximately the same size as the pin hole and filed down the washer on one side directly in front of the hole creating a small channel the pin could slide in on its way to the hole in the collar. I left it a little shallow so the pin would still require a bit of light tapping to install. When done I put just the washer in a vise and twisted it around 90 deg. so the pin would not work its way free.
-John
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top