block heater

i have a 4320 that has a frost plug heater but it dont work very well any more and i want to put a recirculating heater on it instead so if i hook the inlet to the block drain and the outlet of the heater to the plug in the back of the water manifold that is for a intercooler if it had one will that work it should because the water flows out of the drain and heats then goes into the manifold then flows down through the head and block and back into the heater i think this should work any input apreciated
 
Intercooler on a 4320?
As long as you are not trying to run hot water downhill before it enters the engine. Or cold water uphill into the heater.
The higher the entry point into the engine and the lower the exit point from the engine. Generally the better the water will circulate.
 
ok yea because the drain plug is the lowest point for it to enter and the plug in the back fo the water manifold is the highest point and as the water cools it will go down into the engine and warm the entire head and block pretty evenly right? the way im thinking of hooking the heater up will make the coolant run backwards through the system instead of the way it flows during engine operation so this shouldnt bother anything right?
 
they never did but they share the same water manifold as a 4620 or late 4520 wich also use intercoolers so instead of using a different manifoldthey just shoved a plug in the hole do you think the heater will open the thermostats and heat the rad and not heat the engine? or will it heat the engine and myabe then heat the rad?
 
The factory tank heater with an internal thermostat will never open a properly working 180F stat.
A huge uncontrolled heater on a small engine in "warm" wind free location might maybe open a stat. It's only wasting electricity.
In your application, don't worry. Heat the coolant to 50-100F and the batteries to 50F. And she will start like summer.
 
yea its a 1500 watt recirculating heater so it sends alot of heat out and we aint gonna heat the batteries and i dont think this heater cuts out at a certain temp it just heats til you unplug it
 
Heating the batteries with a battery blanket is simple and easy. It allow them to produce 2,3 even four times as much power as a cold battery.
The starter will last longer too with higher battery power.
Warm batteries also take a charge much faster/better too.
 
ill look into that so after all ive told you you think my setup should work and not open the thermostats and heat the engine thank you very much for all of your help
 
That's exactly how my 1500 watt tank heater is plumbed on my Ford 8700. I plug it in for about 2 hours at -20 and hook the battery charger on at 10 amps at the same time.
Chris
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top