Borg Warner transmission

This may or may not be the appropriate place to post this. If not please forgive me. I have several Hahn Hiboy sprayers that run the Borg-Warner T-9 4 speed transmissions in them. There is a caged needle roller bearing (reference # 6 ) that rides in between the input ( figure # 5) and output (figure # 10) shaft. I have exhausted all of the local venues to get a correct one. I can get a shorter, fatter version of it but it requires machining the shafts to fit and it dosent hold up well. Anyone know of a likely source ? I have already tried Kaman and Motion Industries. I've got another one on the way out now. Any help is appreciated. Thanks.
 
Pics didn't load.
cvphoto91084.jpg


cvphoto91085.jpg
 
Is there a part number stamped on the cage? Next thing would be to gather the dimensional information; what size shaft it rides on, the diameter of the bore it sits in and the width of the bearing. I've spent hours searching for bearings on the Internet and it can be done, just takes time, patience and perseverance.
 
I had an original empty bearing box with the part # on it that I saved but I've hid it from myself. I'll have to get a set of shafts measured and post back.
 
Summit Racing, and H.A.M.B seem to have parts. They might be loose rollers. If the roller chain sprocket is unsupported on the far side from the output shaft, the main shaft bearing (what it is called) can fail. If there are variations in diameter of the snout on the main shaft, or the inside of the input shaft, they will also bind and fail. Jim
HAMB
 
What condition is the shaft and inside of the input gear?

Those are hardened surfaces, if the surface has flaked off a new bearing won't fix it.

I agree with Jim, belt driving the input without support is putting a load on that bearing it was never intended to carry.
 
Take a look at 27009H IH part number or Borg Warner #X-4044 as used in Studebaker and
Diamond T. The above info is from Borg Warner gear book. Below are some part numbers from the internet that may or may not be correct.
IHC 214006H1
IHC 27009H
IHC 559863R91
IHC 74333R91
SKF 1-111668
SKF 1-130281
 
Can't help with the bearing, but I had a Hahn like that. I just had to many hills, a lot tippy and not enough traction. What I really wanted was a Hahn 600,never could find one.
 
Thank you everyone for the suggestions and part numbers. I honestly don't know how it holds up as good as it does the way it's made. All the other bearings are still easily obtainable. Bearing # 6 is always the first to fail in them tho.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top