(quoted from post at 06:36:58 06/29/22) Do NOT USE Dot 5! It is pure silicone, a heavier (more viscous) fluid difficult to bleed and not compatible with other brake fluids. The system must be disassembled, totally rebuilt to work. Flushing with alcohol as recommended by some does not work. Silicone, because it does not absorb moisture as traditional fluids do is a specialty fluid used in the antique automotive world (vehicles not driven regularly) and the commercial aviation (extreme high temps). It is a study in itself and too extensive a discussion for here. Traditional fluids should be flushed yearly with fresh as it absorbs moisture and that leads to internal corrosion and failure of traditional systems. Lots of info and it's pretty black and white, not speculative. This comes from 35 years in the road/racing competitive world and years of teaching. There's a reason it's recommended by new vehicle dealerships to flush brake fluid yearly. Larry
(quoted from post at 22:31:12 06/29/22)(quoted from post at 06:36:58 06/29/22) Do NOT USE Dot 5! It is pure silicone, a heavier (more viscous) fluid difficult to bleed and not compatible with other brake fluids. The system must be disassembled, totally rebuilt to work. Flushing with alcohol as recommended by some does not work. Silicone, because it does not absorb moisture as traditional fluids do is a specialty fluid used in the antique automotive world (vehicles not driven regularly) and the commercial aviation (extreme high temps). It is a study in itself and too extensive a discussion for here. Traditional fluids should be flushed yearly with fresh as it absorbs moisture and that leads to internal corrosion and failure of traditional systems. Lots of info and it's pretty black and white, not speculative. This comes from 35 years in the road/racing competitive world and years of teaching. There's a reason it's recommended by new vehicle dealerships to flush brake fluid yearly. Larry
Larry, DO USE DOT 5! We all know the benefits, and when I switched mine over flushing was no problem at all. I simply put the DOT5 in and started bleeding. The DOT 5 fluid is the same light viscosity as the DOT 4. I had a vinyl tube on the fitting while bleeding making it easy to see exactly what was coming out. There was obvious mixed fluids for maybe three cycles until it cleared out. I went five more cycles after there was no more residual. Simple, No big deal. It costs a little more but it is cheap insurance against water damage of your baby. A no brainer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy