(quoted from post at 06:24:52 11/21/20) The Hammer mill doesn't have any mercy on any thing that goes in the chute,and gets reground until it falls threw the screen!
For years my dad and I used to change screens when going from grain to hay. In later years I found that the oats were broken up enough just by going through the big hole hay screen so I never changed again. Just as well because the grain screen was worn so thin it was almost worn out. I do the same on this replacement IH mill. It has a screen with big square holes for hay and straw. I use it for oats and they are just fine. No need to grind them up into flour for cattle feed.(quoted from post at 08:23:16 11/21/20) Screen with small holes, grinds fine and screen with large holes grinds course... There could be as many as ten different screens with different hole sizes........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy