C-301 combine engine

[IN560]

Anyone know if a C301 out of a IH 715 combine has the pilot bearing hole drilled in the crank? I thought I read a post somewhere where someone said it wasn't. Thanks

 

[VicS]

I tend to think it is, but Don't know about yours.

 

[IN560]

I'm not sure why it wouldn't be but I looked a little at the crank once I got the clutch off and it sure didn't look drilled for one but it's got a lot of crud to dig out too. I'll update when I get it cleaned out good and confirm. If it's not do you know any good machines shops that I coukd send it to to have it done? VICS I was just thinking but shouldn't the pilot be in the flywheel and not the crank like some other engines? Thanks for tge help.

 

[IFM puller]

The pilot bearing goes in the flywheel on all C221- C301 tractor applications.

 

[Gary Mitchell]

I had a couple of different C-153's drilled. About any machine shop can do it. I'd let them know how deep and took the bushing along. gm

 

[IN560]

Thanks for the help guys!

 

[VicS]

You are right. Sorry I wasn't thinking.