Case 2090 remote problems

[kenney970]

I have a 2090 with triple remotes and the center remote will not respond in either position. But it will work when one of the other remotes is engaged at the same time. Thanks in advance for any suggestions.

 

[mEl]

Sounding to me like the o rings in the sensor check ball port are blown. Replace all while you have the valve on the bench. There are sensor check balls in each remote section. it would be good if you had a factory service manual to walk you through the repair.

 

[kenney970]

You are suggesting to just
rebuild the one remote. And yes I
do have the factory service
manual on this tractor. Thanks a
million.

 

[casetrader]

I have found the simpliest way to do this is take all 3 off as a unit, do not split,on the back you will find a screw driver slot bump it w/a hammer first then remove,o-ring will probably be gone,do all three an you should be ready to go

 

[mEl]

Replace all while you have it on the bench, 3 sections, all have orings which are probably the same age. Suggestion, use OEM o rings I have found general grade orings in some applications do not do well.

 

[kenney970]

Thank you all for your knowledge. I will let you know how it goes.